BRAYER BR1092, Инструкция по эксплуатации

Страница: 7 / 44

7 EN
THERMOPOT IS INTENDED FOR HOUSEHOLD USE
ONLY, DO NOT USE THE COFFEE MAKER FOR
COMMERCIAL OR LABORATORY PURPOSES.
BEFORE USING THE THERMOPOT
After unit transportation or storage at low
temperature keep it for at least 3 hours at room
temperature before switching on.
• Unpack the thermopot and remove all the packaging
materials.
• Keep the original package.
• Read the safety measures and operating
recommendations.
• Check the delivery set.
• Examine the thermopot for damages, in case of
damage do not plug it into the mains.
• Make sure that the specifications of power supply
voltage specified on the label correspond to the
specifications of your mains. When using the
thermopot in the mains with 60 Hz frequency, the unit
does not need any additional measures.
• Wipe the outer surface of the unit body (10) with a
clean, slightly damp cloth to remove dust.
• Open the lid (4) by pressing the button (5) and
holding it (pic. 1).
• Wipe the inner surface of the thermopot flask with a
clean, slightly damp cloth to remove dust. Close the
lid (4).
SWITCHING THE THERMOPOT FOR THE FIRST
TIME AND USING THE UNIT
• Place the thermopot on a dry flat surface keeping at
least 20 cm gap between the thermopot body and
the wall or furniture and at least 50 cm gap above the
thermopot.
• Open the lid (5) by pressing the button (5) and
holding it (pic. 1).
• • Fill the thermopot with water using a suitable bowl,
do not exceed the maximal water level mark (14)
«FULL» (pic. 2). Do not fill the thermopot with water
directly from the faucet; to fill the thermopot use a
suitable bowl.
Notes: to reduce the mineral deposit (scale), we
recommend using the water cleaned with domestic
filters.
• Close the lid (5) until the lock clicking, make sure that
the lid (5) is closed.
Notes: when using the thermopot, always check the
sealing gasket (13). If you find any cracks on the sealing
gasket (13), stop using the thermopot and apply to the
service center to replace the gasket (13).
• Insert the power cord (20) jack into the connector
(11) on the thermopot body, and the
• power cord (20) plug into the mains socket.
• The boiling mode indicator «Boiling» (16) will light up
on the control panel (3) and the keep warm indicator
(17) «Keep warm» will light up.