Braun MOVIPORT C118 Series, Руководство пользователя

Страница: 16 / 24

14
Manual C118 EN Rev04 04.2017 14
Programming the C118
List of Program Steps (effective only in VAR mode)
Step Function handled Page
00 minimum measuring time, determines sequence (by steps) 15
01 maximum measuring time, determines low speed (by steps) 15
02 Computing factor: multiplying mode = parameter 0
dividing mode = parameter 1
16
03 Computing factor: number of factor decimals 16
04 Computing factor: numerical value of factor 16
05 Speed display readings position of decimal point 16
06 Analog output reading assigned to high end 17
07 Analog output reading assigned to low end 18
08 Automatic power off parameter 0 = no, 1 = after 10 min 18
09 Input frequency divider factor (001…255) 18
10 Totalizing function position of decimal point at SF 19
Programming Procedure
Note: Programming can be done in both modes FIX and VAR.
Programmed characteristics however get valid in VAR mode only.
In FIX mode, all functions are as listed on page 5.
Press key PROG to enter the programming phase. Step 00 appears blinking. To
enter a higher or lower step, use keys
,
or.
.
The thus addressed program No.
blinks.
When in the desired step (see list of steps above or at bottom of the instrument),
use key to enter the parameter. Numerical parameters are set digit by digit,
starting at the right end digit. The one addressed blinks. Select higher or lower
values by the keys , or . Move to the next digit to the left by key , and set
this accordingly. With parameters to be set step by step, or as decimal point po-
sition, use to move it. When the parameter is properly set, touch key PROG to
acknowledge, and move to next program step. Set it, following the same proce-
dure. Before leaving a step, acknowledge by PROG.
To leave the programming phase touch key PROG again.
Note: all parameters are kept safe, when the unit is switched off.