Braukmann 1390, Оригинальное руководство по эксплуатации

Страница: 43 / 116

43
The first weld on the
cut off piece of the roll
is not being carried
out.
Roll is not positioned correctly
Follow the steps in the
chapter “Vacuum packaging
in a bag originating on the
roll”
A complete vacuum is
not being created in
the bag.
The open end of the bag is not
completely inside the vacuum
chamber
Position the bag correctly
The bag is defective Select another bag
There is dirt on the welding and
the normal seals Clean the seals and retry
correctly once they are dry
The bag is not being
welded correctly
The welding bar is overheating so
that the bag melts
Open the cover on the unit
and let it cool down for a few
minutes
The bag does not hold
the vacuum after it has
been welded shut
The bag is defective
Select another bag; wrap
paper serviettes around any
sharp edges on the content
There are leaks along the welding
seam as a result of creases,
crumbs, grease or liquids.
Open the bag again and
clean the upper internal part
of the bag and remove any
foreign matter that might be
on the welding bar before
you weld the bag shut again.
Please note
► If you are unable to solve the problem with the steps shown above, please contact
Customer Service.
19 Disposal of the Old Device
Old electric and electronic devices frequently still contain valuable materials. However,
they also contain damaging substances, which were necessary for their functionality and
safety.
If these were put in the non-recyclable waste or were handled incorrectly, they
could be detrimental to human health and the environment. Therefore, do not
put your old device into the non-recyclable waste under any circumstances.
Please note
►
Utilise the collection point, established in your town, to return and recycle old electric
and electronic devices. If necessary, contact your town hall, local refuse collection
service or your dealer for information.
►
Ensure that your old device is stored safely away from children until it is taken away.