Removing the transport
safety devices
All transit bolts and packing
must be removed before using
the appliance.
You are advised to keep all the
transport safety devices for re-use
in case the machine is to be
transported again.
1. Using a spanner unscrew and
remove the rear right bolt.
2. Lay the machine gently on its
back, making sure that the hoses
are not squashed.
3. Remove the polystyrene base and
take off the bottom panel by
unscrewing the central screw.
P0457
P0255
4. Carefully slide out the right
polythene bag.
5. Repeat the operation for the left and
central polythene bag.
6. Re-fit the bottom panel using the 4
screws supplied with the door
hinges (in the plastic bag) and the
previously removed screw.
P0453
P0016
P0015
7. Set the machine upright and
remove the two remaining bolts
from the back.
8. Pull out the three plastic spacers
from the holes into which the bolts
were fitted.
9. Plug the open holes with the plugs
which are supplied with the
instruction booklet.
P0020
P0256
Positioning
Before positioning the machine in its
definitive place, rotate the inlet hoses
at the back of the appliance in order
to suit the water supply system. To do
this: loose the ring nuts, position the
hoses and tighten the ring nuts again
to prevent leaks.
Install the machine on a flat hard
floor.
Make sure that air circulation around
the machine is not impeded by
carpets, rugs etc. Check that the
machine does not touch the wall or
other kitchen units.
Never place cardboard, wood or
similar materials under the machine to
compensate for any unevenness in
the floor.
Levelling
Level the washing machine by raising
or lowering the feet. The feet may be
tight to adjust as they incorporate a
self locking nut, but the machine
MUST be level.
P0021
36
Installation
37
Installation
