Brandt UD2202, Инструкция по установке и эксплуатации

Страница: 13 / 20

If the model has a fixed vertical or
horizontal handle, unscrew it from the
left side and screw it to the right side
(fig. 16), by moving the protecting plugs
that close the holes.
Should the model have a hinged handle,
remove cover G (fig. 17) by unscrewing
the screw that is protected by a small lid.
Unscrew the handle L from the left side,
position it on the right side and make
the 4 fixing holes ø 3 mm by using the
handle it self as reference. Screw the
handle to the door and replace the cover
G. Unscrew the small contrasting block
H from the left and position it to the
right, aligning it to the handle and fitting
it perfectly on to the edge of the unit.
N.B. Do not use the drill to make
holes in the unit, the drill can be used
to make holes on the door.
Screw with the self tapping screw
supplied (there are no previous holes).
Seal the hole on the left with the small
plug supplied separately. Insert the
protecting plugs (supplied in the small
bag) into the holes of the left side (fig.
18).
13
REVERSIBILITY OF THE
DOOR
Reversibility of the handle
The opening of the door is normally on the left hand side of the equipment (the hinges are
on the right.) Should you require the opening on the right hand side, you could undertake
the change by following the instructions detailed hereunder.
1. Unfasten the screws which secure the base (R0)
2. Lay the equipment gently on its back (with the door facing upwards).
3. Remove the skirting by inserting your hands under it, and pull the levers downwards
that you will find towards the middle, and unhook the skirting by rotating it upwards
(R1). Remove the lever from its left seat and place it on the right seat (R2).
4. Unscrew the lower hinge (R3), unscrew the right pivot and re-screw it on the left (R4)
5. Remove the door of the freezer (R5) from the pivot of the upper hinge.
6. Unscrew the upper hinge (R6) and put it on the left (R7).
7. Insert the door on to the pivot of the upper hinge which is now on the left (R8).
8. Insert the pivot of the lower hinge (R3) modified as per item 4 above, in the left seat at
the bottom of the door, and re-screw the hinge to the equipment (R9).
9. Replace the skirting, refasten the screws and reposition the equipment vertically.