Brandt TE670 Series, Руководство по установке и использованию

Страница: 62 / 88

62
DURING OPERATION • •
YOU OBSERVE THAT… WHAT SHOULD YOU DO?
4 / SPECIAL MESSAGES, INCIDENTS
• Lighting the burners:
There are no sparks when you press the
knobs.
• When you press on a knob, there are
sparks on all of the burners simultaneously.
• In reduced heat mode, the burner goes
out or the flames remain high.
• The flames look irregular or uneven.
• During cooking, the knobs become hot.
If the hob has a gas safety device: during
lighting, the flames light, then go out as
soon as the knob is released.
Triple-Crown Burner:
The flames are yellow on the small central
burner.
Small flames or no flame on the small
central burner.
. Check the electrical connection of your appliance.
. Check that the spark plugs are clean
. Check that the burners are clean and properly assembled
. If the hob is attached to the work top, check that the mounting
brackets are not deformed.
. Check that the gaskets under the knobs are not coming out of their
lodging.
This is normal. The lighting function is centralised and controls all of the
burners simultaneously.
. Avoid strong air currents in the room.
. Check that the gas type being used matches the injectors installed
(Read about markings on the injectors in the “Changing the Gas Supply”
chapter).
Reminder: The cooking hobs are sold pre-set for use with network gas
(natural gas).
. Check that the burner power screws are properly set (See the
“Changing the Gas Supply” chapter).
. Check the cleanliness of the burners and injectors under the burners,
the assembly of the burners, etc.
. Check that there is enough gas in the bottle.
. Use small saucepans on the burners located closest to the knobs.
Large cookware should be used on the largest burners, which are
farther away from knobs. Properly place the saucepan in the centre of
the burner. It should not go over the edge onto the knobs.
. Press firmly down on the knobs and hold them down for a few seconds
after the appearance of flames.
. Check that the parts of the burner are correctly mounted.
. Check that the gaskets under the knobs are not coming out of their
lodging.
. Avoid strong air currents in the room.
. Light your burner before placing your saucepan on it.
Check the correct usage of the small central burner depending on the
gas used. (see page 12)
If the burner has caked on dirt, unblock all the holes located under the
small central burner.
Clean the pressing area on the small central burner.
99641921_A_FR_EL_EN_PT.qxp 23/02/2007 14:13 Page 62