Brandt BXP5471X, Руководство пользователя

Страница: 28 / 36

ENGLISH
You may resolve certain little problems yourself:
The oven is not heating.
Check that the oven is
correctly connected and that your installation’s fuse
is not out of service. Increase the selected
temperature.
The oven light is not working.
Replace the bulb
or the fuse. Check that the oven is correctly
connected.
The cooling fan continues to operate after the
oven stops.
This is normal; the fan may continue
running until a maximum of 1 hour after cooking to
lower the temperature inside and outside the oven.
If the fan runs for over an hour, contact the After
Sales Department.
The pyrolysis cleaning cycle does not begin.
Check that the door is locked. If there is a door
locking or temperature sensor fault, contact the
Customer Services Department.
The symbol flashes in the display.
Door
locking fault; contact the Customer Services
Department.
Anomalies and solutions
7
5.4
REPLACING THE OVEN LAMP
Bulb specification:
15 W, 220-240 V~, 300°C, E14 cap.
To unscrew the view port and the light, use a
rubber glove, which will make disassembly easier.
6.1
MENU
You can adjust different
settings on your oven. To
do so:
Press
until you get to
the “MENU” display to
access the settings mode.
Press again to scroll through the different set-
tings.
Activate or de-activate the different parameters
with
+
and
-
; see table below:
+
Settings
6
To exit the “MENU”, press again.
AUTO: In cooking mode ,
the light inside the oven
automatically turns itself
off after 90 seconds.
ON: In cooking mode ,
the light is on all the time.
Activate/de-activate the
beeping sound of the
buttons
Activate/de-activate pre-
heating mode
Activate/de-activate
demonstration mode
Use a tool (screwdriver) to press the slots A in order
to unclip the glass panel.
Remove the glass panel.
Depending on the model, the door consists of two
additional glass panels, with a black rubber spacer
at each corner. If necessary, remove them to clean.
Do not soak the glass panels in water. Rinse with
clean water and dry off with a lint-free cloth.
RE-ASSEMBLING THE DOOR
After cleaning, reposition the four rubber stops with
the arrow upwards.
Reposition all of the glass panels.
Slip the last glass panel into the metal stops, then
clip it in with the shiny side facing outwards.
Remove the plastic wedge.
Your appliance is now ready for use again.
Warning:
Make sure the appliance is disconnected
from the power before replacing the lamp
in order to avoid the risk of electric
shock. Change the lamp only when the
appliance has cooled down.