19
4.
CLEANING AND MAINTENANCE
For hygienic reasons, the appliance
(including
exterior
and
interior
accessories) should be cleaned regularly
at least every two months.
Caution!
The appliance must not be
connected to the mains during cleaning.
Danger of electrical shock! Before
cleaning switch the appliance off and
remove the plug from the mains socket.
Exterior cleaning
Clean your appliance regularly to
maintain its good appearance.
-
Wipe the digital panel and display panel
with a clean, soft cloth.
-
Spray water onto the cleaning cloth
instead of spraying directly on the
surface of the appliance. This helps
ensure an even distribution of moisture
to the surface.
-
Clean the doors, handles and cabinet
sur- faces with a mild detergent and
then wiped dry with a soft cloth.
Caution!
-
Don’t use sharp objects as they are
likely to scratch the surface.
-
Don’t use Thinner, Car detergent,
Clorox, ethereal oil, abrasive cleansers
or organic solvent such as Benzene for
cleaning. They may damage the
surface of the appliance and may cause
fire.
Interior cleaning
You should clean the appliance interior
regularly. It will be easier to clean when
food stocks are low.
Wipe the inside of the fridge freezer with
a weak solution of sodium bicarbonate,
and then rinse with warm water using a
wrung-out sponge or cloth. Wipe
completely dry before replacing the
shelves and baskets.
Thoroughly dry all surfaces and
removable parts.
Although this appliance automatically
defrosts, a layer of frost may occur on
the freezer compartment’s interior walls if
the freezer door is opened frequently or
kept open too long. If the frost is too
thick, choose a time when of food stocks
are low and proceed as follows:
1.
Remove
existing
food
and
accessories
baskets,
unplug
the
appliance from the mains power and
leave the doors open. Ventilate the
room thoroughly to accelerate the
thawing process.
2.
When defrosting is completed, clean
your freezer as described above.
Caution!
Don’t use sharp objects to
remove frost
from the freezer
compartment. Only after the interior is
completely dry should the appliance be
switched back on and plugged back into
the mains socket.
Door seals cleaning
Take care to keep door seals clean.
Sticky food and drinks can cause seals
to stick to the cabinet and tear when
you open the door. Wash the seal with
a mild detergent and warm water.
Rinse and dry it thoroughly after
cleaning.
Caution!
Only after the door seals are
completely dry should the appliance be
powered on.
Replacing the LED light:
Warning: The LED light must not be
replaced by the user! If the LED light is
damaged, contact the customer helpline
for assistance. To replace the LED light,
the below steps can be followed:
1.
Unplug your appliance.
2.
Remove light cover by pushing up
and out.
3.
Hold the LED cover with one hand
and pull it with the other hand while
pressing the connector latch.
4.
Replace LED light and snap it
correctly in place.
Cleaning and care
