INSTALLATION INSTRUCTIONS
Step 10: Use a T20 Torx bit to remove the subwoofer
box. (If equipped)
Step 11: Using a plastic trim removal tool, pry off rear
seat belt closeout.
Step 12: Using a plastic trim removal tool, remove rear
access panel to expose 10mm bolt, and remove bolt.
Step 13: Pull out subwoofer box slightly to gain access
to run Chassis Harness along existing harness
Step 14: Pull back the carpet and continue running
Chassis Harness forward.
Step 15: Run Chassis Harness under B-pillar cover to
passenger door sill. Use a plastic trim removal tool to
remove the (2) plastic push pins and remove passenger
sill plate/kick panel.
Step 16: Use a 10mm socket to remove the existing nut
located behind the passenger kick panel and attach
ground eyelet of Chassis Harness to chassis ground.
Step 17: In the factory wire harness located in the
passenger's footwell, locate the White/Gray Reverse
signal wire and splice Green Reverse wire from supplied
9002-8817 Instructions
Page 4 of 7
