703739-1 Revision D Spider Glazier 2200 Operator's Manual Issue Date: 2019-Jan-25
Page 15 of 27
d) Outreach Installation
Step 1:
Lift the Outreach so that the lower Outreach Hinges are
adjacent to the lower Backspan Hinges, and the holes
for the pin line up.
NOTE: Do NOT tighten hinges on Outreach or
Backspan so that the distance between the upper and
lower beam flanges is reduced below 8 inches.
Step 2:
Insert pin through lower holes and secure with hairpin
clip attached on lanyard, as shown in Figure 10.
Step 3:
Uncoil the top limit switch cable from the Outreach and
route across the Outreach and the Backspan. Secure
with tie wraps through the tie wrap holders attached to
the Outreach and Backspan.
Step 4:
Pivot the Outreach up so that the upper holes in the
Outreach Hinges line up with the upper holes in the
Backspan Hinges.
Step 5:
Insert pin through upper holes and secure with hairpin
clip attached on lanyard, as shown in Figure 10.
Step 6:
Remove tie wrap from Limit Switch lanyard so that the
shackle hangs free, as shown in Figure 11.
Step 7:
Once hoist is installed (see Page 19), connect Limit
Switch below pendant connection on the electrical box.
Top Pin in place
Figure 10: Outreach Bottom Pin
Installation and Limit Switch Power
Cord Routing
Limit Switch
and Shroud
Shackle
Tie Wrap Holders
Figure 11: Outreach Top Pin Installation
Limit Switch
Cable routing
Continues
Behind
Backspan
Bottom Pin
in place
Power Supply
Cord Connection
Pendant
Connection
Limit Switch
Connection
