Brammo Enertia 2010, Руководство пользователя, Страница: 59 / 92

Brakes
Brake Pad Wear
(Refer to Safety Precautions on pages 44 & 45)
Brake pad wear depends upon the severity of usage, the type of riding, and road conditions. Generally,
the pads will wear faster on wet and dirty roads. Inspect the pads at each regular maintenance interval.
Always inspect both pads in each brake caliper. Always replace brake pads as a set.
Front Brake Pad Inspection (MINIMUM BRAKE PAD MATERIAL THICKNESS = 1mm)
(1.) Remove the 2 pin-retaining clips. (2.) Remove the pin. (3.) Remove both brake pads. (4.) Measure the thickness of the remaining brake pad material,
replace pads if thickness is less than 1mm. (5.) Reinstall pads into caliper housing, install pin, install 2 pin-retaining clips.
Rear Brake Pad Inspection (MINIMUM BRAKE PAD MATERIAL THICKNESS = 1mm)
(1.) Remove the pin-retaining clip. (2.) Remove the pin. (3.) Unbolt caliper housing from swingarm and remove. (4.) Remove both brake pads.
(5.) Measure the thickness of the remaining brake pad material, replace pads if thickness is less than 1mm. (6.) Reinstall pads into caliper housing, install
caliper housing and bolt onto swingarm (torque bolts to 15 ft-lbs, 20Nm), install pin, install pin-retaining clip.
Servicing Your Enertia 59
   
WARNING
During all the operations described below,
the caliper oil inlet hose must NOT be
disconnected.
1. Remove the retaining clips 2. Remove the pin 3. Remove brake pads 4. Measure material thickness
1. Remove the retaining clip 2. Remove the pin 3. Remove brake pads 4. Measure material thickness