Brammo 2013 Empulse, Руководство пользователя

Страница: 71 / 112

Maintenance
Servicing and Maintaining Your Empulse 69
5. Use the measuring marks, “teeth” on the chain adjusters aligned
with the end of the swing arm to check the alignment of the
swingarm. Make sure that the mark positions are equal on the
left and right sides. If the rear axle is misaligned, turn the right or
left adjusting bolts until the distances are equal.
6. Torque the rear axle nut to 55 Nm.
Note:
If a torque wrench is not used during installation, see your
Brammo Authorized Dealer as soon as possible to verify proper
assembly. Improper assembly may lead to loss of braking capability.
7. Tighten the drive chain adjusting bolts lightly by turning them
counter-clockwise, then tighten the lock nuts by holding the
drive chain adjusting bolts with a wrench.
8. Recheck the drive chain tension.
Cleaning
Wipe down the O-ring chain with a rag and soapy water, rinse it off
with a light spray of water, and when it dries, lubricate the chain with
O-ring safe chain spray. The only maintenance an O-ring chain
requires is to be kept in adjustment and lubricated regularly to
prevent corrosion.
Lubrication
Lubricate with a high quality lubricant every 300 miles (500 km), or
sooner if the chain appears dry. When operating in wet, hot, dry,
and/or dusty conditions, you may need to lubricate the chain more
frequently.
Removal and Replacement
Note:
Removal of the chain is not required for normal maintenance.
Replace of the drive chain requires specialized equipment and should be
carried out by your Brammo Authorized Dealer.
WARNING
Always clean a chain after contact with road salt or salt water and
then lubricate with a recommended lubricant.
Recommended lubricants O-Ring and X-ring chain compatible.
Apply as directed on can. Use a rag to
prevent over spray on the Empulse,
especially on the tires and brake rotors.
Empulse.book Page 69 Thursday, June 27, 2013 11:03 AM