Fusion MCT Wireless Recorder
27
Recommended Separation Distances
Refer to the following table for recommended separation distances
between Fusion and portable and mobile RF communications
equipment.
Fusion is intended for use in an electromagnetic environment in which
radiated RF disturbances are controlled. The user of Fusion can help
prevent electromagnetic interference by maintaining a minimum
distance between portable and mobile RF communications equipment
(transmitters) and Fusion as recommended below, according to the
maximum output power of the communications equipment.
Separation distance according to
frequency of transmitter
Rated maximum
output power of
transmitter
W
150 kHz
to 80 MHz
d
= 1.2
P
80 MHz
to 800 MHz
d
= 1.2
P
800 MHz
to 2,5 GHz
d
= 2.3
P
0,01 0,12
0,12
0,23
0,1 0,38
0,38
0,73
1 1,2
1,2
2,3
10 3,8
3,8
7,3
100 12
12
23
For transmitters rated at a maximum output power not listed above,
the recommended separation distance
d
in meters (m) can be
estimated using the equation applicable to the frequency of the
transmitter, where
P
is the maximum output power rating of the
transmitter in watts (W) according to the transmitter manufacturer.
NOTE1: At 80 MHz and 800 MHz, the separation distance for the
higher frequency range applies.
NOTE 2: These guidelines may not apply in all situations.
Electromagnetic propagation is affected by absorption and reflection
from structures, objects and people.
Fusion MCT Wireless Recorder
28
FCC / IC Statements
NOTICE: This device complies with Part 15 of the FCC Operation
is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operation.
NOTICE:
Changes or modifications made to this equipment not expressly
approved by Braemar, Inc. may void the FCC authorization to
operate this equipment.
NOTE: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the
equipment and receiver.
Connect the equipment into an outlet on a
circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced
radio/TV technician for help.
