Brady Bradyprinter THT 300X-PLUS, Руководство пользователя

Страница: 59 / 180

Printer Operation
Print a Configuration Label
Bradyprinter THT X-Plus II Series User Guide 31
Print a Configuration Label
When you have loaded the media and ribbon (if necessary), print a configuration label
to use as a record of your printer settings. Keep the configuration label for baseline
information on your printer when troubleshooting printing problems.
To print a configuration label, complete these steps:
1.
Connect the power cord to the power connection on the back of the printer.
2.
To confirm the power connection, turn the printer On (
I
).
The printer performs the power-up self test (POST). When the test is complete,
PRINTER READY
displays on the front panel LCD.
3.
Does the front panel LCD display
PRINTER READY
?
• Yes — continue with the next step.
• No — go to Troubleshooting on page 111 .
4.
Turn the printer Off (
O
).
5.
Press and hold CANCEL while turning the printer On (
I
).
6.
Release CANCEL when the DATA light turns off (approximately five seconds).
The configuration label prints. A sample label, which may look different than
yours, is shown below.
Caution •
For personal and equipment safety, always use an approved three-
conductor power cord specific to the region or country intended for installation. This
cord must use an IEC 320 female connector and the appropriate region-specific three-
conductor grounded plug configuration.