24
Configuration Instructions
Edition 3/07
Configuration
BP-PR PLUS series
Tab. 10:
Parameters of the menu
Setup
>
Print param.
Error-Reprint
On
: With a correctable error and corresponding troubleshooting, the label
being printed when the error occurs is repeated.
Off
: Print job is continued with the next label.
On
Pause reprint
Printing of another label with the information of the previous print job by
pressing the
pause
button. This function can be executed until the print
buffer is cleared with the
cancel
button.
Off
Protocol error
On
: Printer switches to Error mode when unknown or faulty data is received.
Off
: When working with older computer operating systems, it is possible
that the print spooler of the operating system will reply to the printer with
normal status messages of the printer (e.g. end of paper) in the form of
ASCII text. The printer cannot interpret this data and outputs a large
number of protocol errors. In this case, it is advantageous if you set the
Protocol error
parameter to
Off
.
Caution
: If the
Protocol error
parameter is set to
Off
, protocol errors
which can be traced back to faulty programming are also ignored. There is
a risk of data loss.
Access only when service key is inserted!
On
Barcode error
On
: With faulty barcode contents or size specifications, printing is inter-
rupted.
Off
: Printing is not interrupted if an error occurs. If barcode contents are
faulty, the printer attempts to replace the incorrect data with valid characters
(e.g. zeros). If barcode size specifications are faulty, a gray area is printed
instead of the barcode.
On
Width ASCII dump
Width of the printing area in the "Monitor mode" test function (see "5.6" on
Page 43).
With the
Automatic
setting, the printout of the control sequences arriving
at the printer occurs over the maximum printing width. You can reduce the
printing area width down to 50 mm.
Automatic
Parameter
Meaning
Default
