6
S19-324D1
Installation
6/11/2020
Bradley •
215-1848 Rev. G: ECO 20-05-028
2 Connect Signaling Assembly to Flow Switch
4 Complete electrical supply connections
WARNING To prevent personal injury and damage to the components, follow all manufacturer's
warnings and instructions when performing any maintenance or installation of
components used in this emergency signaling system.
A
Remove the access cover by rotating
the cover counterclockwise.
B
Run provided electric power conduit
and hubs into an unused 3/4" conduit
port of the control box. Connect the
provided wires in the conduit to the
floating terminal block per the wiring
schematic.
Compliance and conformity to local codes and
ordinances is the responsibility of the installer.
D
Once the connections are made,
close the access cover by rotating
clockwise and sealing the control
box.
The cable may be cut to any length required.
A
Wire the flow switch to the control
box with one of the provided cables
and conduit hubs supplied per
the wiring schematic. Refer to the
instruction manual supplied with the
conduit hubs for proper installation.
5 Conduit Seals
A
Unit is provided with sealing
compound and conduit seals.
Seals must be filled by installer
prior to powering the unit per seal
manufacturer's instructions.
To prevent water condensation from dripping onto
the flow switch, make sure the cable is not taut.
See wiring diagram and schematic
included in documentation packet.
Seal
Seal
Seal
Seal
3 Attach Beacon and Area Lights (if applicable)
A
If unit is ordered with optional area
and beacon lights, remove lights
from their individual boxes.
B
Screw beacon and/or area light
onto pendant mount in appropriate
location. Make sure light is securely
screwed to pendant mount.
C
Plug any remaining holes with plugs
provided.
Do not exceed 14 AWG wire.
