EFX 120/S19-2350
Installation
8
12/7/2017
Bradley
• 215-1818 Rev. B; ECN 17-09-009
C
If the rod travels less than1/2
"
, the piston is not
moving freely within the liner and they must be
cleaned:
1. Remove the control section assembly, top
cap and thermostat.
2. Unthread the liner from the cap (it is glued
together; the o-rings must be removed and
heat should be applied to melt the glue and
loosen the liner).
3. Clean the piston and liner with any cleaner
suitable for brass and stainless steel (400-
grit sandpaper may be used to polish and
hone the piston and liner).
WARNING To prevent injuries, use proper protective
equipment for eyes and skin when using
a propane torch.
Thermostat
Top Cap
with Pushrod
B
Insert a 7/16
"
dia. rod into the valve until it touches
the top of the pushrod that is attached to the
piston. Mark the length of the rod inside the valve.
Push the rod until the piston stops and mark the
new length.
D
Push the mechanism up and down several
times to make sure the piston moves smoothly
and consistently. If it is not consistent, repeat
Procedure C until it moves freely, or replace.
Contact your Bradley representative and ask for
Piston/Liner Kit (part number S65-422).
A
Remove the valve’s top cap and pull out the
thermostat. You may use a needle-nose pliers
to remove the thermostat from the valve body if
desired.
7/16"
Rod
Piston Overheat
Chamber
The second mark
should be 1/2"
higher on the rod
than the first mark.
Troubleshooting: Piston Disassembly and Cleaning
