To modify the MVM, start by fl attening the existing bends shown in
picture 1 on the left. Place the MVM on the fl at spot of the bench vise and
pound out the bends until the MVM is fl at and looks like picture 2 on the
left.
Use the tin snips to cut away the parts of the mount that are not needed
as shown in Picture 3 on the left. Once the MVM is cut, bend the remain-
ing tab into a 90 degree angle. The bend does not need to be a sharpe
90 degree bend, it just has to bend enough to allow you to mount it using
the exsiting screw hole as shown on page 1.
Return to step 3 on page 1.
MVM MODIFICATION INSTRUCTIONS
••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••
MVM Instructions |
Page 2
5
The Bracketron MVM-15-05 mount is a modifi able mounting bracket. The illustrations on the left show how this mount should
look during and after the modifi cation steps in order to fi t the listed vehicles on the front page of this manual.
Many vehicle
applications may not require any modifi cations to the mount. If this is the case it will be noted below and there will be no steps
to follow on this page.
PLEASE NOTE
© Bracketron Inc, 2007 All rights reserved.
The information in this document is subject to change without notice. Bracketron Inc. assumes no responsibility for any errors that may appear in this document nor
do we assume any liability in connection with its use. This supersedes and voids all previous literature. Please contact the sales department for additional information.
Bracketron Inc will not be responsible or liable for damage to vehicles in the installation and or removal of this Bracketron Inc mount. Bracketron Inc will not be liable
for personal injuries or damage to property resulting from a motor vehicle accident and or improper installation of this Bracketron Inc mount.
Note:
Please see page 3 in this manual for PHS-
203 Ultra Slim Swivel Instructions.
Bracketron Inc
5249 West 73rd Street, Suite G, Edina, MN 55439
tel:
952-746-7775
fax:
1-800-660-1784
toll free:
1-866-237-4443
email:
web:
www.bracketron.com
Note:
The hole pattern on the face of the
MVM maybe different then what is shown in
the pictures.
6
Picture 2
Picture 1
Flatten Mount Here
Picture 3
Existing Bends
Cut On Red Lines
Bend Mount
