IMPORTANT INFORMATION
••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••
MVM Instructions |
Page 1
IMPORTANT INFORMATION
Please read instructions completely before installing this Bracketron MVM Mount. All instructions are written from the drivers
seat vantage point looking forward at the vehicles dash. We advise caution whenever you are removing or handling plastic
parts of a vehicles dash.
WARNING:
Unnecessary force or pressure can cause pieces to crack or break.
PARTS INCLUDED:
MVM-15-05 Mount, 3- #8x3/4” Self Tapping Screws PHS-203 Ultra Slim Swivel, and Hardware
TOOLS NEEDED FOR MVM MODIFICATION
(
if required
)
4 inch Mounted Bench Vise
12 oz. Ball Pein Hammer
Standard Tin Snips
Small File
TOOLS NEEDED FOR DASH PANEL DISASSEMBLY
Dash Trim Tool (Part #SIT-104)
7mm Socket and Driver
9/32” Open End Wrench (for swivel)
#2 Phillips Screwdriver
DASH DISASSEMBLY INSTRUCTION
••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••
Begin installation by removing the bezel that surrounds the radio and climate
control. There are 5 metal retainer clips around the perimeter and 3 plastic
clips near the top that secure this bezel. When bezel is removed, set it aside
carefully.
Skip to
Step 5
on the following page if you have not yet formed the bracket
to fit your vehicle.
With a Phillips screwdriver (or 7mm socket and driver), locate and remove
the screw directly to the right side of the climate control. Set the screw aside.
Place the MVM over the screw hole and replace factory screw. Note: Make
sure the MVM is resting tightly against the right side of the dash bezel
Carefully reinstall the dash in reverse order securing the dash bezel into its
original position. Note: You will feel and hear a “click” when all 8 clips are
secured.
If Desired, Install the included Ultra Slim Swivel #PHS-203 to your Multi
Vehicle Mount or any other AMPs compatible device.
Your installation is complete
Install Mount Here
1
2
3
4
Note:
The hole pattern on the face of the MVM maybe
different then what is shown in the pictures.
