46
Programming Manual-
System Programming
IT
EN
DE
FR
ES
PT
ASSIGN CALLS
y
Manual programming is possible only if the system is composed of a single entry panel (DDVC/08 VR-DDC/08
VR)
.
In the instance where the DC/08-DVC/08 entry panel is present, you must initiate manual program-
ming of system DDVC/08 VR-DDC/08 VR as described below.
In such a case, it is not necessary to execute programming via the VA/08 power supplier; the other DC/08-
DVC/08 entry panels will be programmed as described in the relative manual.
Using this menu, you can assign each internal extension the corresponding call code.
To enter the programming mode, use the key .
Once you have entered the programming mode, the system will be-
gin a self-learning phase.
When finished, the LEDs on the entry panel will light up as shown
in the figure to the side.
To continue programming, press the key .
When the screen shown to the side appears, follow the procedure
described below in order to assign the call code to the internal ex-
tension.
Lift the receiver
(if present) of the extension that you want to pro-
gramme and press the door lock release
and Aux 2
keys
a
.
To assign the call code, select the desired group using the arrows
and confirm by pressing
.
An acoustic signal will confirm that the programming was success-
ful
b
.
Assign Calls
Codes
Names and Calls
General Settings
Main Menu
ESC
Hold on
Assign Calls
ESC
WXYZ
PQRS
TUV
JKL
MNO
ABC
DEF
GHI
Lingua
Attendere
Program. impianto
ESC
WXYZ
PQRS
TUV
JKL
MNO
ABC
DEF
GHI
Lingua
Attendere
Program. impianto
ESC
WXYZ
PQRS
TUV
JKL
MNO
ABC
DEF
GHI
Lingua
Attendere
Program. impianto
ESC
to continue
Press
Assign Calls
ESC
in programming
mode
Set the receiver
Assign Calls
ESC
b
Antonio Bianchi
Luca Viola
Gianni Verdi
Mario Rossi
Select Group
ESC
beep
a
