Boya BY-WM8 Pro, Руководство пользователя

Страница: 28 / 177

Set up “MONO” and “STEREO”
For how to Set up “MONO” and “STEREO”, please refer to page 16.
Troubleshooting
If you have any problem using the BY-WM8 Pro components, use the following checklist.
If any problem persist, please consult our local dealer, or contact us directly.
Symptom Meanings Remedy
The units does
not turn on
The polarity orientation of
the batteries in the battery
compartment is incorrect. Insert the batteries with
the correct polarity
orientation.
The batteries are
exhausted. Replace the batteries with
new ones.
The battery terminals in
the transmitter are dirty Clean the + and – terminals
with cotton swab.
The batteries become
drained quickly.
The batteries are
exhausted. Replace the batteries with
new ones.
Manganese batteries are
being used.
Use alkaline batteries. The
battery life of a manganese
battery is less than half
that of an alkaline battery.
The BY-WM8 Pro
components is being used
under cold conditions.
The batteries drain quickly
under cold conditions.
The channel cannot be
changed
An attempt was made to
change the channel by
pressing the SET button
only.
Restart the unit, then
change the channel with
the + and - buttons.
There is no sound.
The channel setting on the
transmitter is different
from that on the receiver. Use the same channel
setting on both the
transmitter and receiver.
The sound is
weak.
The attenuation level on
the transmitter is too high.
The input level of the
transmitter is low. Press
the button on the
transmitter in attenuation
level setting mode to
decrease the attenuation
level.
The line input is selected
on the transmitter. Pull the cable out from
LINE IN.
There is distortion in the
sound The attenuation level on
the transmitter is too low. The input level of the
receiver is extremely high.