BTUN-02
AM/FM TUNER WITH RS232
TO PRESET MEMORIES
1. Select a desired station.
2. Press MENU button slowly until MEM and ENTER characters flash.
3. Press ENTER button.
4. Select desired PRESET number by pressing UP or DOWN button.
5. Press ENTER button.
EZ Steps:
1. Select desired station
2. Press MENU four times
3. Press UP or Down
4. Press ENTER button
CHANGING IR CODE
1. Press MENU slowly five times or until IR1 or IR2 or IR3 is flashing.
2. Press ENTER to stop flashing.
3. Press UP or DOWN to cycle through the three codes to display the one desired.
4. Press ENTER (or wait 3 seconds)
RDS INFORMATION
RDS information is not shown on the BTUN-02 display but is only available for connected third party devices via the RS232
connection.
Remote Control Functions
Remote control is optional available. HEX IR codes for third party integration can be found in the rear of the manual.
The BTUN-02 Remote Control is intuitive to use, but a few important functions are described below.
MEM Button:
If you press and hold this button for four seconds, the BTUN-02 automatically searches for stations and
saves them in 32 (maximum) memory locations. It starts from the FM band, and then switches to the AM band. The first
station found will be saved to preset number 06, and will continue until the preset number 32 is filled. Preset numbers 01 to
05 are reserved for manual programming of your favorite stations.
