Bowflex SelectTech 560, Инструкция по сборке и эксплуатации

Страница: 11 / 16

Problem Solution
Handle Assembly does not fully insert into Base when
no Weight Plates are selected (handle has no plates
attached).
Use a vertical motion to return the Handle Assembly. Do not tilt or move laterally the
Handle Assembly.
Handle Assembly does not fully insert into Base when
Weight Plates are selected (handle has plates attached).
Check to see if you have selected different weights on each of the dumbbells (for
example one dumbbell is set to 10 and the other is set to 15). If this is the case, you
must replace the Handle Assembly into the corresponding Base.
Verify that the Weight Plates not selected (those plates remaining in the Base Assembly)
are in their correct spots and have not been moved to a different support slot. This may
be blocking the dumbbell from fitting back into the Base.
Check to see if there is any dirt, debris or other obstruction in the Base. Remove
anything found from the Base. You may need to remove the weight plates from the Base
to accomplish this check. Place each Weight Plate back in the appropriate location and
orientation.
Adjustment Grip will not turn while Handle Assembly is
in Base.
Check to be sure that the Handle Assembly is fully depressed into the Base. If not
fully depressed, the locking mechanism will not be released and may be keeping the
Adjustment Grip from rotating.
Check to see if there is any dirt, debris or other obstruction in the dumbbell Base.
Remove anything found from the Base. You may need to remove the Weight Plates from
the Base to accomplish this check. Place each Weight Plate back in the appropriate
location and orientation.
Display shows Battery Icon Replace batteries.
Troubleshooting
Assembly / Owner’s Manual
11