Bowflex LateralX LX3, Руководство по обслуживанию

Страница: 8 / 54

8
TROUBLESHOOTING
Condition/Problem Things to Check Solution
No display/partial display/unit
will not turn on
Check electrical (wall) outlet Make sure unit is plugged into a functioning wall outlet.
Check power adapter Check for visual sign that power adapter is damaged. Replace power adapter
if damaged.
Check connection at front of unit Connection should be secure and undamaged. Replace adapter or connec-
tion at unit if either are damaged.
Check data cable integrity All wires in cable should be intact. If any are visibly crimped or cut, replace
cable.
Check data cable connections/
orientation
Be sure cable is connected securely and oriented properly. Small latch on
connector should line up and snap into place.
Console Display If Console only has partial display and all connections are fine, replace the
Console.
If the above steps do not resolve the problem, contact Customer Service (if
inside US/Canada) or your local distributor (if outside US/Canada).
Unit operates but Contact HR
not displayed
HR cable connection Be sure cable is connected securely at top of Console Mast.
Sensor grip Be sure hands are centered on HR sensors. Hands must be kept still with
relatively equal pressure applied to each side. If there is plastic film on the
HR sensor, carefully peel off the film.
Dry or calloused hands Sensors may have difficulty with dried out or calloused hands. A conductive
electrode cream (heart rate cream) can help make better conduct. These are
available on the web or at medical or some larger fitness stores.
Static Handlebar If tests reveal no other issues, Static Handlebar should be replaced.
Resistance does not change
(machine turns on and
operates)
Check data cable connections/
orientation
Be sure cable connections at top and bottom of Console Mast are connected
securely and oriented properly. Reseat all connections. Small latch on con-
nector should line up and snap into place.
Resistance handlebar
connection
Be sure cable from Static Handlebar and cables to Console are secure and
undamaged.
If the above steps do not resolve the problem, contact Customer Service (if
inside US/Canada) or your local distributor (if outside US/Canada).
Console shuts off (enters sleep
mode) while in use
Check connection at front of unit Connection should be secure and undamaged. Replace adapter or connec-
tion at unit if either are damaged.
Check data cable connections/
orientation
Be sure cable connections at top and bottom of Console Mast are connected
securely and oriented properly. Small latch on connector should line up and
snap into place.
Check Speed Sensor (requires
shroud removal)
Speed sensors should be aligned with magnet and connected to data cable.
Realign sensor if necessary. Replace if there is any damage to the sensor or
the connecting wire.
Unit rocks/does not sit level Check leveler adjustment Adjust levelers until machine is level.
Check surface under unit Adjustment may not be able to compensate for extremely uneven surfaces.
Move machine to level area.
Machine slides from side to side
during operation
Floor surface The machine may slide on a hard surface. Put the machine on a rubber
machine mat, which will provide a non-slip surface.
Foot pedals loose/unit difficult
to operate
Hardware Tightly secure all hardware on the Pedal Arms and Handlebar Arms.
Click, tick or knocking sound Check for loose hardware Tightly secure all hardware.
Check foot assemblies, leg as-
semblies, handlebar assemblies
Manually move foot, leg, and handlebar assemblies to isolate sound. Contact
Customer Service (if inside US/Canada) or your local distributor (if outside
US/Canada).