Page 8
40245-0-0219
FINISHING EXTERIOR DECORATIVE FRONT
NOTICE:
The
fireplace must be protected during finishing. Do not
allow acid wash to get onto the fireplace.
1. The stainless may be covered in full or in part by a
non-combustible stone, tile or other finishing material. It is
recommended that the outer perimeter face of the outdoor
kit be covered with non-combustible finishing material.
See Figure 11.
OUTSIDE
INSIDE
Figure 11
2. Sheathing and framing may be placed to the stainless top,
bottom and side surfaces. The back side of the outdoor kit
and the top surface of the fireplace are non-combustible
zones.
See Figure 12.
Figure 12
3a.
Figure 13
shows
minimum recommended coverage over the
face of the outdoor kit. This covers rivets exposed on the
outside of the fireplace. The non-combustible facing may be
placed to the opening.
See Figure 13.
5/8
”
Figure 13
3b. Exterior non-combustible finishing material is placed over the
face of the outdoor kit.
See Figure 14.
EXTERIOR
NON-COMBUSTIBLE
FINISHING
MATERIAL
RESIDENCE
WALL BOARD
Figure 14
4. Insert the screen assembly into the top of the outer glass
frame. Bring the bottom of the screen assembly against the
face. Lower the screen assembly to catch the shoulder
screw on the side of the glass.
See Figure 15.
1st
2nd
Figure 15