![Bostitch BRN175 Скачать руководство пользователя страница 5](http://html1.mh-extra.com/html/bostitch/brn175/brn175_operation-and-maintenance-manual_2795065005.webp)
5 - ENG
TOOL PARTS:
Fig. 1
A. Exhaust deflector
B. Selectable trigger
C. Canister
D. Door latch
E. Safety contact tip
F. Depth adjustment wheel
G. Door
H. Tool-Free Shingle Guide
I. Trigger lock button
J. Mode selector button
ASSEMBLY:
Disconnect air line from tool, engage trigger lock and remove
fasteners from magazine before making adjustments or personal injury may
result.
TRIGGER
Keep fingers AWAY from the trigger when not driving fasteners to
avoid accidental actuation. Never carry a tool with finger on the trigger. In bump
action mode (contact actuation mode), the tool will drive a fastener if the contact
trip is bumped while the trigger is depressed.
The BRN175 is equipped with a selectable trigger. This trigger allows the operator
to select either single sequential action trigger mode or bump action trigger mode.
In accordance with the ANSI Standard SNT-101-2002, the trigger is assembled
in the single sequential action trigger mode. To change the trigger mode, see
Actuating Tool
instructions in the
Operation
section of the manual. The selectable
trigger also has a trigger lock button to keep the trigger locked at all times when
the tool is not in use.
AIR FITTING
This tool uses a 1/4" N.P.T. male plug. The inside diameter should be .275" (7mm)
or larger. The fitting must be capable of discharging tool air pressure when
disconnected from the air supply. A 3/8" (9.5 mm) male quick connector coupling
is available from BOSTITCH and may be used when a 1/4" (6.4 mm) supply line is
not available.
NOTE:
A 3/8" (9.5 mm) supply line (and fittings) are required for maximum tool
performance.
Always use couplings that relieve all pressure from the tool when it
is disconnected from the power supply. Always use hose connectors that shut off
air supply from compressor when the tool is disconnected.
A
E
I
J
F
B
C
H
D
G
BRN175_9R209323_MAN_kf V2_multi.indd 5
1/28/15 7:41 AM