19
MACHINE SET UP GAS MIG WELDING - CONTINUED
7
8
Re install tip and nozzle to torch and trim wire
to the end of the nozzle.
Remove nozzle and tip from torch and press
the wire feed button inside the machine door,
this will feed the wire through the torch.
Release button when wire appears at the end
of the torch.
NOTE: make sure your torch is
straight and has no kinks while you feed the
wire through it.
Refer to the chart on the front of the machine,
and set your voltage and wires speed dials to
the according settings, once you start to weld
you can make finer adjustment to suit.
11
10
Fit gas regulator to the gas bottle and install
gas hose to the gas inlet on the back panel of
welder.
Turn on regulator and set gas flow to between
10-15 L/min depending on your welding
environment.
9
NOTE:
It is advisable to run a few test welds
using scrap or offcut materials, in order
to tune the machine to the correct
settings prior to welding the job.
NOTE:
Wire speed will run a full speed when
the trigger is pressed without
making and arc.
Note:
Pictures may vary from your machine model
