Videos: BosStrap Features
https://vimeo.com/72150591
9/8/14 Rev 6
Installation and Fitting
https://vimeo.com/72150592
6. Thread the G3 Tail through the left
camera strap lug from top.
9. Thread the Generation 3 Tail under
the cam lock lever and through the
sleeve. Allow about 1” of webbing
to go beyond the cam buckle. When
you next open the cam buckle, pulling
on this end will make it easier to open.
7. Continue threading the G3 Tail
back through the small triglide as
shown in the figure at left. Snug
up as shown in Fig 10 leaving
about 2” between the camera lug
and the narrow end of the cam
buckle, Fig 11.
10. Snap the cam lock closed.
You will hear and feel a secure snap.
8. Lay flat the body strap with the BosStrap
logo facing up. Insert the Generation 3
Tail end from under the metal slide as
shown in Fig 8 .
11. Push the vinyl sleeve on the cam
lock to secure the cam lever. The
sleeve is designed not to completely
cover the closed cam buckle.
Final Adjustments
Now, put on the BosStrap with the camera and lens attached and adjust the BosStrap so that the camera is at a
comfortable location by your right hip and your hand falls naturally on where you grip the camera. After you fine tune the
BosStrap length, extra slack beyond the buckle can be neatly secured with the included triglide. Small adjustments to the
G3 Tail length and the BosStrap can make big differences in comfort.
When not using the camera, turn it so the lens points down and backward for minimal camera movement when walking.