Videos: BosStrap Features
https://vimeo.com/72150591
10/14 Rev 7
Installation and Fitting
https://vimeo.com/72150592
(508) 480-9762
BosStrap Generation 3 LT Installation and Fitting Instructions
Initial Fit Adjustment of the BosStrap Sling Strap
The BosStrap body strap should be approximately adjusted to fit you before the G3 Tail is attached
to the camera. Begin by opening the BosStrap body strap to a larger than needed loop. Put your
head and right arm through the BosStrap.
The BosStrap should be over your left shoulder, across
your chest under your right arm with the nylon fittings at your back. Leave the free end of the strap
dangling down until the final adjustment is made.
The BosStrap is on correctly when the BosStrap
logo on the front is properly oriented as shown in the photograph at right. The BosStrap length
should be adjusted so that the bottom of the metal slide plate is at your right side, a few inches
above your hip.
Attaching the Generation 3 Tail to your Camera
1. The G3 Tail as shipped is attached to the metal glide fiting.
2. Work the vinyl sleeve back to access the cam lock. On new
products, the sleeve tends to be a little stiff. This will relax in time.
3. Open the cam lock and release the G3 Tail from the metal slide.
It is easier to open the cam buckle lever by pulling on the 3/8” strap
end, rather than using a finger nail to open it.
4. Remove the small triglide on the G3 Tail. Leave the vinyl sleeve
on the G3 Tail.
5. Rethread the end of the G3 Tail through
the triglide as shown.
BosG3LT
