•
Speed dial—increases the spinner motor speed
when turned clockwise, and decreases the spinner
motor speed when turned counterclockwise.
•
Green LED—indicates that the controller is on and
the spinner motor is turning
•
Yellow LED—indicates that the Blast switch is
active
•
Red LED—indicates that the spreader is clogged
and the controller is being overloaded
Specifications
Note:
Specifications and design are subject to
change without notice.
Hopper height
53 cm (21-7/8 inches)
Hopper width
74 cm (29 inches)
Hopper depth
38 cm (15 inches)
Weight (empty)
31 kg (70 lb)
Capacity
0.08 m
3
(3 ft
3
)
Operation
Note:
Determine the left and right sides of the
machine from the normal operating position.
Removing the Spreader
1.
Ensure that the spreader controller is in the O
FF
position.
2.
Unplug the spreader wire harness from the
vehicle wire harness and attach the weather
caps to each end.
3.
Unhook the ratchet straps.
4.
Remove the cotter hairpin and clevis pin from
the vehicle hitch.
5.
Slide the spreader out of the receiver hitch of
your vehicle (
).
DANGER
The spreader is heavy and could cause
serious injury if dropped.
Ensure that your footing is stable, and
avoid lifting the spreader on slippery or
uneven surfaces.
g232362
Figure 8
6.
Move the spreader to your storage area.
Mounting the Spreader
DANGER
The spreader is heavy and could cause
serious injury if dropped.
Ensure that your footing is stable, and avoid
lifting the spreader on slippery or uneven
surfaces.
1.
Slide the hitch on the spreader into the receiver
hitch of your vehicle and line up the second hole
8
