Boss Snowplow MSC13950, Руководство по установке

Страница: 1 / 12

Form No. MSC13989 Rev F
Low Flow Hydraulic Kit
for Grandstand ® Multi Force Snow Machine or Mower
Part No. MSC13950
Installation Instructions
Safety
Improper use or maintenance by the operator or
owner can result in injury. To reduce the potential
for injury, comply with these safety instructions
and always pay attention to the safety-alert
symbol
, which means Caution , Warning , or
Danger —personal safety instruction. Failure to
comply with the instruction may result in personal
injury or death.
•
Read the Owner’s Manual before operating or
servicing the equipment.
•
Ensure that only trained personnel install and
maintain the equipment.
•
Keep your hands, feet, and clothing away from
moving parts and mounting points.
•
Never put any part of your body between the
hydraulics and the machine.
Installation
Determine the left and right sides of the machine from
the normal operating position.
Preparing the Machine
1. Park the machine on a level surface, shut off the
engine, wait for all moving parts to stop, engage
the parking brake, and remove the key.
2. Support the machine on jack stands.
3. Release the cushion for rear access according
to the instructions in your Grandstand Multi
Force
Operator’s Manual .
Note:
You can also remove the fuel tank at
this time; refer to your Grandstand Multi Force
Operator’s Manual .
4. If a mower deck is attached to the machine,
remove it according to the instructions in your
Grandstand Multi Force
Operator’s Manual .
5. Place the front frame cross-tube on a jack and
raise the machine until the caster wheels clear
the ground.
6. Remove the outer bolts and nuts securing the
caster wheels in place (
Figure 1 ).
g036932
Figure 1
Right Caster Shown
1. Outer bolt and nut 2. Rear wheel position
7. Rotate the caster wheels to the rear position and
secure them with the previously removed bolts
and nuts (
Figure 1 ).
© 2019—BOSS Products
P.O. Box 787
Iron Mountain, MI 49801 Register at www.bossplow.com. Original Instructions (EN)
Printed in the USA
All Rights Reserved
*MSC13989* F