- Set minutes:
Holding down
DSP
button (5) for several seconds, and the clock is blinking on
the display, press button (13) to adjust the minutes.
• LIQUID CRYSTAL DISPLAY
The
LCD
(4) can show the current state of the unit.
• RESET
Reset button (29) must be activated with either a ball point pen or thin metal object.
The reset button is to be activated for the following reasons:
- Initial installation of the unit when all wiring is completed.
- All the function buttons do not operate.
- Error symbol on the display.
RADIO OPERATION
• SELECTING BAND
Press
BAND
button (11) to change between three FM bands and two AM bands.
Each band stores up to six preset stations.
• SELECTING STATION
During radio mode, press
MAN/SKP
button (13) to increase frequency or (14)
to decrease frequency by one step of channel spacing. Hold the button longer for
fast tuning. The frequency is updated correspondingly on display.
• SELECTING MEMORY
Press preset memory buttons (15) to preset stations at tuner mode. With this
system, a total of 30 stations can be stored in the memory of six buttons.
The stations might be FM1, FM2, FM3, AM1 and AM2 band.
The operation is as below:
- Store in Memory
Press and hold desired memory location button for several seconds. The current
listening station will be stored into the number button.
- Retrieve a Preset Station
Press any one of the buttons (15) to retrieve a station which had been stored in
the memory in advance the chosen number is shown on display.
• AUTO MEMORY STORING & SCANNING
- Auto Memory Scanning
Check the stations stored in the preset memories.
Press to retrieve automatically the current stations stored in six preset memories
and it will display for several seconds. Press either the
AS/PS
button (16) again
or anyone of the memory buttons to stop the scan operation. During the preset
scan operation, the channel number flashes on the display for several seconds.
Preset station scan continuously in the pre-selected band.
10
FM1
FM2
FM3
AM1
AM2
