Page 10
Page 5
Note:
1. Make sure use a speaker with 4 ohm loa d impedance.
2. Do not make the auto antenna wire and ground touch each other.
3. Front AUX IN and rear AUX IN can not be con nected to at the same time.
WIRING DIAGRAM
+
+
+
+
YELLOW
CONSTANT
12 Volts
GROUND
IGNITION SWITCH
12 Volts
FRONT
REAR
RIGHT
FRONT
WHITE
WHITE/BLACK
GREEN/BLACK
VIOLET/BLACK
GRAY/BLACK
GRAY
VIOLET
GREEN
REAR
LEFT
SPEAKER
-
-
-
-
BLUE AUTO ANT
10A FUSE
FILTER
BOX
0.5 A FUSE
SPEAKER
RED R
WHITE L
RCA LINE OUT
REAR(GRAY)
RED R
WHITE L
RCA LINE OUT
FRONT(BLACK)
WOOFER LINE OUT
YELLOW
ANTENNA PLUG
RED R
WHITE L
AUX LINE IN
(BROWN)
BLACK
RED
RADIO OPERATION:
1. To select radio band
2. To select the radio station manually or automatically
3. To store the current station or turn on the preset station
4. To automatically store for the strongest stations and scan for each stored stations
5. To scan for strong signal of radio station
6. STEREO/MONO BUTTON
7. LOC BUTTON
Under RADIO mode, press the BAND button shortly and repeatedly to select
your desired radio band in sequence and circulation as follows:
-->FM1-->FM2-->FM3-->AM1-->AM2-->
.
Under RADIO mode, short press the >>| or |<< button repeatedly to manually tune
up or down for the desired radio station step by step. Long press the >>|/ |<< button
to automatically tune up or down for the radio station of strong signal.
A) Press one of 1-6 number buttons hold for more than 1 second until the second
beep output to store the current station in the preset memory bank of the number
button for the current band. So the unit can store 30 preset stations.
B) Press one of 1-6 number buttons shortly to turn on the preset station stored in
the preset memory bank of the number button for the current band.
A) Long press the AS/PS button, it will search from the current frequency and check the
signal strength until 1 cycle search is finished on current band, and then 6 strongest
stations will be preset to the corresponding preset memory banks of the 6 number
buttons. When the auto-storage operation is completed, it will turn on the preset
station stored in the memory bank of the 1 button.
B) Short press the AS/PS button to scan for each preset station for the current band.
When the field strength level is more than the threshold level of stop level, the radio
is holding at that preset station for 5 seconds with releasing mute, while memory
digital and frequency will flash on LCD, and then scan again.
In FM band, FM1, FM2 and FM3 is checked one at a time.
Press SCAN button to scan up by one channel step with station detection. If a
valid signal has detected, the current frequency is blinked within 5 seconds, then
press it again to stop scan and remain the current frequency; otherwise, the unit
continue to scan up by one channel step with station detection 5 seconds later.
In FM mode, press the MO/ST button to select the STEREO or MONO sound mode.
A) In FM mode, when the signal of the distance radio station are very weak and
the receiving effect is bad during tuning, check whether there is the word LOC
on LCD. If there is the word LOC on LCD, press this button to turn off the LOC
function, then tune again for the distance radio station;
PDF created with FinePrint pdfFactory trial version
http://www.pdffactory.com
Содержание 740UA
Страница 1: ......
