Faults and what to do about them
en
45
Faults and what to do about them
hot
The door cannot be opened after the drying programme due to the high tempera-
ture. The cooling process continues until the display disappears, after which the
door can be opened.
¹
■
Flashes
(no water supply): Tap turned on? Water inlet filter blocked? Clean
Water hose kinked or blocked?
■
Lights up
(low water pressure): For information only. This will not affect the
programme progress. The programme duration is extended.
E:18
Drain pump blocked; clean the drain pump. Clean the drainage hose
on the siphon.
ªªª
■
Hold down button
5
(Drying)
for 3 seconds to delete the display.
■
Clean the air filter.
■
Run the
Fluff Clean
l
Ž
(cold) programme without laundry.
LO kg
,
HI kg
Laundry amount information. On when drying phase finished.
LO kg
: Signals a small load for drying,
HI kg
: Signals a very high load for drying.
Other displays
Turn the programme selector to
Ú
Stop
. The appliance is switched off. Wait 5 s
and switch on again. If the display is indicated again, call customer service.
Faults
Cause/Remedy
Water is running out.
■
Correctly attach/replace drainage hose.
■
Tighten screw-fitting on the supply hose.
Water not flowing in.
Detergent not dispensed.
■
Start
/Reload
A
not selected?
■
Tap not open?
■
Filter blocked? Clean the filter
■
Supply hose kinked or jammed?
The washing machine
door cannot be opened.
■
Safety function active. Stop programme?
■
$
(Rinse stop = without final drain/spin) selected?
■
Can be opened with emergency lock release only?
■
Childproof lock active? Deactivate.
Programme does not
start.
■
Start
/Reload
A
or
5
(
Finish in
) selected?
■
Door closed?
Detergent solution is not
drained.
■
$
(Rinse stop = without final drain/spin) selected?
■
■
Clean outlet pipe and/or drainage hose.
Water not visible in the
drum.
Not a fault – water below the visible area.
Display
Cause/Remedy
