Installation and connection
en
17
Caution!
Damage to the appliance/fabrics
If the end of the outlet hose is immersed
in the drained water, water may be
sucked back into the appliance and
may damage the appliance/fabrics.
Make sure that:
■
The plug does not block drainage
from the wash basin.
■
The end of the drain hose is not
immersed in the drained water.
■
The water drains away quickly
enough.
Note:
Do not kink the water drain hose
or stretch it lengthways.
Installing the drainage hose:
Secure the outlet hose so that it cannot
slip out.
Elbow available from after-sales service:
Individual part number 00655300
Drainage into a siphon
The connection point must be secured
using a hose clamp with a diameter of
24–40 mm (available from specialist
dealers).
Connecting
Drainage into a plastic pipe
with rubber sleeve or into
a gully
Connecting
Alignment
1.
Loosen the lock nut in a clockwise
direction with a wrench.
2.
Check the alignment of the washer
dryer with a spirit level and, if
required, correct. Adjust the height
by rotating the appliance foot.
Note:
All four appliance feet must
be firmly on the floor.
The washer dryer must not wobble!
3.
Tighten the lock nut against the
housing.
Grip the foot and do not adjust the
height.
Notes
■
The lock nuts on all four appliance
feet must be screwed tightly against
the housing!
■
Any loud noises, intense vibrations
or “wandering” may be due to
incorrect alignment!
