Faults and what to do about them
en
45
Information on the display panel
Display
Cause/Remedy
Õ
■
Flashes fast + signal
: The door was opened and the water level is too high.
Close the door, continue the programme with
A
Start/Pause
button or
select
Spin
0
.
■
Flashes slowly
: The door lock temperature is too high to open the door. Wait
approx. 30 seconds until the door lock temperature cools down.
Hot
The temperature in the drum is too high. Wait for the appliance running to cool
down the laundry till the
Hot
disappears on the display panel, then the door can be
opened.
r
■
Flashes
(no water supply): Water tap turned on? Filter in the water supply is
"Filter in the water supply is blocked" on page 43
Is the supply hose kinked or trapped?
■
Lights up
(low water pressure): For information only. This will not affect the
programme progress. The programme duration is extended.
E
lights up
The childproof lock is activated – deactivate it.
The symbol
Û
flashes
Run the
¡
Drum Clean
programme to clean and care for the drum and the outer
tub.
Notes
■
Run the programme without laundry.
■
Use washing powder or a detergent containing bleach. To prevent foaming,
only use half the amount of detergent recommended by the detergent manu-
facturer. Do not use detergent designed for woollens or delicates.
■
Switching the drum care information signal on/off.
E:36
alternating with
-10
■
Drain pipe or water drain hose is blocked. Clean the drain pipe and the water
outlet hose.
■
Drain pipe or water drain hose is caught or jammed. Ensure that the drain pipe
and water drain hose are not kinked or trapped.
■
The drain pump is blocked.
"Drain pump is blocked" on page 42
■
The drain hose at the siphon is blocked.
"The drain hose at the siphon is blocked" on page 43
■
The water drain hose is connected too high. Install the water outlet hose at a
maximum height of 1 meter.
E:35
alternating with
-10
(Suitable for spe-
cial models)
There is water in the base trough, the appliance is leaking. Turn off the tap. Call
customer services.
H:95
alternating with
End
when programme is
finished
No water detected in drying phase, may get bad drying result.