Bosch WKD28350GB Installation Instructions, Instructions for Use, Programme Table, Инструкции по ремонту

Страница: 18 / 32

Fault Cause Fault correction Advise customer
“Drain/Spin” or “Drain” programme
is not run Water temperature NTC > 60 °C
(N1)
Before draining, a cool down is run
until the water temperature < 60 °C
is reached (max. filling time 3').
If T < 60 °C is not reached within
3 min., only the drain cycle is run. This may occur if the user stops the
wash programme and selects
“Drain/Spin” or “Drain”
Air temperature “ NTCD1 ” > 68 °C
(N0)
Before draining, a cool down is run
until the air temperature NTCD1 <
60 °C is reached (max. filling time
10'). If NTCD1 < 60 °C is not
reached within 10’, only the drain
cycle is run. This may occur if the user stops
the drying programme and selects
“Drain/Spin” or “Drain”
"Rinse/Spin" programme is not run Water temperature NTC > 60 °C
(N1)
Before the programme starts,
“cool down” is run until the water
temperature < 60 °C is reached
(max. filling time 3'). This may occur if the user stops
the wash programme and selects
“Rinse/Spin”
Air temperature “ NTCD1 ” > 68 °C
(N0)
Before the programme starts, a
cool down is run until the air
temperature NTCD1 < 60 °C is
reached (max. filling time 10'). This may occur if the user stops
the drying programme and selects
“Rinse/Spin”
Drying programme is run without
warm spin cycle NTC washing solution tub ( NTCD1 )
defective
Check NTC washing solution tub
(NTCD1), if required replace.
Drying time too long NTCD1 or NTCD2 defective. No
error on the display, extended
drying time.
Check NTCD1 and NTCD2 and,
if required, replace.
815_58300000146136_ara_en_b.doc – 12.04.10 Seite 18 von 32