en
Faults and what to do about them
46
Information on the display panel
Display
Cause/Remedy
Õ
■
Flashes fast + signal
: The door was opened and the water level is too high.
Close the door, continue the programme with
Start/Pause
A
button or
select
0
Spin
.
■
Flashes slowly
: The door lock temperature is too high to open the door. Wait
approx. 30 seconds until the door lock temperature cools down.
r
■
Flashes
(no water supply): Water tap turned on? Filter in the water supply is
blocked?
"Filter in the water supply is blocked" on page 44
If an additional water filter has been installed (depending on the model), check
for contaminants and clean if required
~
separate installation and cleaning
instruction for water filter.
Is the supply hose kinked or trapped?
■
Lights up
(low water pressure): For information only. This will not affect the
programme progress. The programme duration is extended.
E
lights up
The childproof lock is activated – deactivate it.
The symbol
Û
flashes
Run the
Û
Drum Clean
programme to clean and care for the drum and the outer
tub.
Notes
■
Run the programme without laundry.
■
Use washing powder or a detergent containing bleach. To prevent foaming,
only use half the amount of detergent recommended by the detergent manu-
facturer. Do not use detergent designed for woollens or delicates.
■
Switching the drum care information signal on/off.
ù
lights up
Only for programmes with automatic dosing activated:
■
The detergent drawer has not been pushed in fully. Push the detergent drawer
in fully.
■
The pump unit is not inserted. Insert the pump unit into the drawer lid.
w
or
©
is flashing
There is not enough detergent/softener in the
w
or
©
dispenser. Add more deter-
gent/softener into the relevant dispenser.
E:10
alternating with
-00
,
-10
or
-20
The pump unit of the automatic dosing system is blocked. Turn the programme
selector to
Off
. Clean the pump unit.
If this indicator/symbol/code appears again, call our after-sales service.
