Bosch WGG2540ESN, Руководство пользователя

Страница: 45 / 52

Troubleshooting
en
45
Fault Cause and troubleshooting
The spin result is not
satisfactory. The laun-
dry is too wet/too
damp. A low spin speed is selected.
▶
The next time you run a wash cycle, set a higher
spin speed.
▶
Start the
Centrifugering
programme.
is activated.
▶
Select the programmes that are suitable for the
type of fabric.
Drain pipe or water outlet hose is blocked.
▶
Clean the drain pipe and the water outlet hose.
Drain pipe or water drain hose is caught or jammed.
▶
Ensure that the drain pipe and water drain hose are
not kinked or trapped.
The unbalanced load detection system has interrupted
the spin cycle because the laundry is unevenly distrib-
uted.
▶
Redistribute the laundry in the drum.
Note:
Where possible, mix large and small items in
the drum. Different sized items of laundry distribute
themselves better during the spin cycle.
▶
Start the
Centrifugering
programme.
Unbalance load detection system is using a reduced
spin speed to eliminate an unbalance.
▶
Redistribute the laundry in the drum.
Note:
Where possible, mix large and small items in
the drum. Different sized items of laundry distribute
themselves better during the spin cycle.
▶
Start the
Centrifugering
programme.
Detergent residue on
the damp washing. Detergents may contain water-insoluble substances
that deposit on the laundry.
▶
Start the
Sköljning
programme.
Detergent residue on
the dry laundry. Detergents may contain water-insoluble substances
that deposit on the laundry.
▶
Brush out the laundry after washing and drying.
Water is leaking out at
the water inlet hose. Water inlet hose is not correctly/securely connected.
1.
Connect the water supply hose correctly.
→
"Connecting the water inlet hose", Page 14
2.
Tighten the screw connection.
Water is leaking out at
the water outlet hose. The water outlet hose is damaged.
▶
Replace the damaged water outlet hose.