en
Faults and what to do about them
44
Foam is leaking from the
detergent drawer.
Too much detergent used?
Mix 1 tablespoon of fabric softener with ½ litre of water and pour into
dispenser
II
. (Not for outdoor, sports and down-filled textiles!)
Reduce detergent dosage for the next wash cycle.
Use commercially available low foam detergent and care product which are
suitable for machine.
Repeated, intensive foam-
ing.
Have you used too much detergent? Add less detergent in the next time you
run a wash cycle with the same load.
Detergent/fabric softener
drips off the seal and col-
lects on the door or in the
seal fold.
There is too much detergent/fabric softener in the dispensers. Do not fill the
dispensers above the
max.
mark.
The spin result is not sat-
isfactory.
Laundry wet/too damp.
■
Not a fault – the unbalanced load detection system has interrupted the
spin cycle because the laundry is unevenly distributed. Distribute small and
large items of laundry evenly in the drum.
■
Is
p
Easy Iron
additional programme setting selected (depending on the
model)?
■
Is
Silent wash
additional programme setting or
Silent wash
programme
selected (depending on the model)?
■
Is the selected speed too low?
The spin cycle runs sev-
eral times.
Not a fault – the unbalanced load detection system is adjusting an imbalance.
The programme is taking
longer than usual.
■
Not a fault – the unbalanced load detection system is adjusting an imbal-
ance by repeatedly distributing the laundry.
■
Not a fault – the foam detection system is activated – a rinse cycle has
been switched on.
The length of the pro-
gramme changes during
the wash cycle.
Not a fault – the programme sequence is optimised for the specific washing
process. This may change the length of the programme shown on the display
panel.
Odours, stain formation in
the appliance.
Run the
Û
Drum Clean 90°C
programme without laundry.
Add washing powder or a detergent containing bleach.
Note:
To prevent foaming, only use half the amount of detergent recommend-
ed by the detergent manufacturer. Do not use detergents designed for woollens
or delicates.
Loud noises, vibrations
and appliance "move-
ment" during the spin
cycle.
■
Is the appliance aligned?
■
Are the appliance's feet fixed? Secure the appliance's feet.
■
Have the transport locks been removed?
The display panel indica-
tor lights do not work
while the appliance is run-
ning.
■
Has there been a power failure?
■
Have the fuses blown? Reset/replace the fuses.
■
If the fault occurs repeatedly, call customer services.
Faults
Cause/Remedy
