en
Faults and what to do about them
42
Information on the display panel
Display
Cause/Remedy
Õ
■
Flashes fast + signal
: The door was opened and the water level is too high.
Close the door, continue the programme with
Start/Reload
A
button or
select
[
Drain
.
■
Flashes slowly
: The door lock temperature is too high to open the door. Wait
approx. 30 seconds until the door lock temperature cools down.
r
■
Flashes
(no water supply): Water tap turned on? Filter in the water supply is
blocked?
"Filter in the water supply is blocked" on page 40
If an additional water filter has been installed (depending on the model), check
for contaminants and clean if required
~
separate installation and cleaning
instruction for water filter.
Is the supply hose kinked or trapped?
■
Lights up
(low water pressure): For information only. This will not affect the
programme progress. The programme duration is extended.
E
lights up
The childproof lock is activated – deactivate it.
The symbol
Û
flashes
Run the
Û
Drum Clean
programme to clean and care for the drum and the outer
tub.
Notes
■
Run the programme without laundry.
■
Use washing powder or a detergent containing bleach. To prevent foaming,
only use half the amount of detergent recommended by the detergent manu-
facturer. Do not use detergent designed for woollens or delicates.
■
Switching the drum care information signal on/off.
E:36
alternating with
-10
and
End
when programme is
finished
■
The drain pump is blocked.
"Drain pump is blocked" on page 39
■
The drain hose at the siphon is blocked.
"The drain hose at the siphon is blocked" on page 40
E:35
alternating with
-10
and
End
when programme is
finished (Suitable for
special models)
There is water in the base trough, the appliance is leaking. Turn off the tap. Call
customer services.
Other displays
Turn the programme selector to
Off
, wait for five seconds and then switch it on
again. If the display appears again, call customer services.
