Bosch WAX02KLOSN, Руководство пользователя и инструкции по установке

Страница: 43 / 60

Troubleshooting
en
43
Fault Cause and troubleshooting
"E:30 / -80" Unapproved extension installed on the water drain
hose.
▶
Remove any unapproved extensions from the water
hose.
→
"Connecting the appliance", Page 15
The pump cap is not fully screwed in.
▶
Ensure that the pump cap is screwed in all the way
into the appliance. The handle on the pump cap
must be in a vertical position.
"E:36 / -25 / -26" Drain pump is blocked.
▶
→ "Cleaning the drain pump", Page 39 .
"E:38 / -25 / -26" Drain pump is blocked.
▶
→ "Cleaning the drum", Page 37
if the fault is displayed again,
▶
→ "Cleaning the drain pump", Page 39
Inlet opening of the rubber gasket is blocked.
▶
→ "Cleaning the intake opening in the rubber gas-
ket", Page 41
"E:10 / -00 / -10 /
-20" The pump for the intelligent dosing system is blocked.
1.
Switch off the appliance.
2.
Clean the pump unit.
→
"Cleaning the detergent drawer", Page 37
3.
Switch the appliance on.
4.
If the display appears again after you clean the
pump unit, call customer service.
→
"Customer Service", Page 55
Note:
You can deactivate and manually dose the intel-
ligent dosing system until the fault is rectified.
→
"Buttons", Page 23
"E:60 / -2B" The unbalanced load detection system has interrupted
the spin cycle because the laundry is unevenly distrib-
uted.
▶
Redistribute the laundry in the drum.
Note:
Where possible, mix large and small items in
the drum. Different sized items of laundry distribute
themselves better during the spin cycle.
"E:30 / -10" and/or The water pressure is low.
No remedial action possible.
The filter in the water inflow is blocked.
▶
Clean the water inflow filter.