Bosch WAX02KLOSN, Руководство пользователя и инструкции по установке

Страница: 49 / 60

Troubleshooting
en
49
Fault Cause and troubleshooting
Drum jerks after the
programme starts. This is caused by an internal motor test.
▶
Not a fault – no action required.
Vibrations and move-
ment of the appliance
whilst spinning. Appliance is not correctly aligned.
▶
→ "Aligning the appliance", Page 16
The appliance feet are not fixed.
▶
Secure the appliance feet.
→
"Aligning the appliance", Page 16
Transit bolts have not been removed.
▶
→ "Removing the transit bolts", Page 13 .
Drum rotates, water
does not flow in. Load detection is active.
▶
Not a fault – no action required.
Note:
The load detection can take up to two minutes.
Heavy foam build-up Detergent dosage is too high.
▶
Immediate measure: Mix one tablespoon of fabric
softener with 0.5 litres of water and pour the mix-
ture into the compartment for manual dosing (not
for outdoor clothing, sportswear or items stuffed
with down).
▶
If intelligent dosing is activated, reduce the basic
dosage →
Page 35 .
▶
If you dose manually, reduce the amount of deter-
gent for the next washing cycle with the same load.
⁠
i-DOS
⁠
i-DOS
cannot be actuated.
Intelligent dosing is not intended for this programme.
▶
Not a fault – no action required.
→
"Starting the programme with intelligent dosing
system", Page 33
Programme progress does not allow intelligent dos-
ing.
No remedial action possible.
High spin speed not
reached. A low spin speed is selected.
▶
The next time you run a wash cycle, set a higher
spin speed.
is activated.
▶
Select the programmes that are suitable for the
type of fabric.
Unbalance load detection system is using a reduced
spin speed to eliminate an unbalance.
▶
Redistribute the laundry in the drum.