Bosch WAK20200IR, Инструкция по эксплуатации и руководство по установке

Страница: 36 / 40

en
Positioning and connecting
36
■
Drainage into a siphon
The connection point must be
secured using a hose clamp with a
diameter of 24-40 mm (available
from specialist dealers).
■
Outlet into a plastic pipe with
rubber bushing or into a drainage
pit
Levelling
Level the appliance using a spirit level.
Incorrect levelling may result in intense
noise, vibrations and "wandering".
1.
Loosen the lock nuts using a
wrench, by turning it in a clockwise
direction.
2.
Check the alignment of the washing
machine with a spirit level, and
adjust it if necessary. Change the
height by turning the appliance feet.
All four appliance feet must stand
firmly on the ground.
3.
Tighten the lock nut against the
housing.
In doing so, hold the foot tight and
do not adjust its height.
The lock nuts on all four appliance
feet must be screwed tightly against
the housing.
Electrical connection
:
Warning
Danger of death!
There is a risk of electric shock if you
touch live components.
■
Never touch or hold the mains plug
with wet hands.
■
Only pull out the mains cable by the
plug and never by the cable, as this
could damage it.
■
Never unplug the mains plug during
operation.
Observe the following information and
ensure that:
Notes
■
The mains voltage and voltage
indicated on the washing machine
(rating plate) are the same.
The connected load and fuse
required are specified on the rating
plate.
■
The washing machine is only
connected to an alternating current
via a properly installed earthed
socket.
■
The mains plug fits the socket.
■
The cable cross-section is adequate.
■
The earthing system is properly
installed.