Bosch WAJ20180MA, Руководство пользователя и инструкции по установке

Страница: 45 / 52

Troubleshooting
en
45
Errors Cause Troubleshooting
Drum does not turn, water
does not flow in. Load detection is active.
▶
Not a fault – no action required.
Note: The load detection can take up
to two minutes.
Noise
Errors Cause Troubleshooting
Rushing, hissing noise. Water is flushed under pres-
sure into the detergent
drawer.
▶
Not a fault – normal operating
noise.
Banging noises, rattling in
the drain pump. Foreign bodies have got into
the drain pump.
▶
→ "Cleaning the drain pump",
Page 35
Loud noises during the spin
cycle. Appliance is not correctly
aligned.
▶
→
"Aligning the appliance",
Page 16
The appliance feet are not
fixed.
▶
Secure the appliance feet.
→ "Aligning the appliance",
Page 16
Transit bolts have not been
removed.
▶
→
"Removing the transit bolts",
Page 14
Slurping, rhythmical suction
noise. The drain pump is active, the
detergent solution is
pumped out.
▶
Not a fault – normal operating
noise.
Problem with results
Errors Cause Troubleshooting
Creasing. The spin speed is too high.
▶
The next time you run a wash cycle,
set a lower spin speed.
The load is too large.
▶
The next time you run a wash cycle,
reduce the amount of laundry being
loaded.
The wrong programme is se-
lected for the type of fabric.
▶
Select the programmes that are
suitable for the type of fabric.
→ "Programmes", Page 22
Detergent or fabric softener
drips off the seal and col-
lects on the door or in the
seal fold. Too much detergent/fabric
softener in the detergent
drawer.
▶
When dosing liquid detergent and
fabric softener, observe the mark-
ing in the detergent drawer and do
not dose above this.
The spin result is not satis-
factory. The laundry is too
wet/too damp. A low spin speed is selected.
▶
The next time you run a wash cycle,
set a higher spin speed.