34
Water does not enter the machine
or detergent is not washed away.
The “wash/ready ” and “spin/end”
indicator lights flash.
Tap not turned on.
Turn the tap on.
Inlet hose kinked or pinched.
Filter blocked in water inlet hose.
Clean the strainer; see from page
32.
Detergent in chamber
I
is not
washed away.
A programme without Prewash
was selected.
Select programme
Cotton
Prewash
T
Water not visible in the drum.
Not a fault.
The water lies below the visible part of the drum.
Washing solution is not completely
drained.The “
rinse
” and “spin/end”
indicator lights flash.
Pumped blocked by foreign objects. Clean the pump (refer to page 31).
Fluff-producing laundry was
washed. The water drainage pipe or
drain hose is blocked.
Clean drainage pipe and/or
drainage hose.
Water runs out from under the
appliance.
Screw fitting of the inlet hose is
leaking.
Tighten the screw-fitting.
Drainage hose is leaking.
Replace the drain hose.
Foam comes out of the detergent
drawer.
Too much detergent or detergent
not suitable for use in washing
machines used.
Mix 1 tablespoon of fabric softener
with
½
litre of water and pour into
chamber
II
of the detergent
dispenser.
Reduce detergent dosage for next
wash cycle or use detergent which
is suitable for use in washing
machines.
The washing has not been spun
correctly.
Large laundry items have become
entangled and are not evenly
distributed in the drum.
For safety reasons, the high-speed
final spin cycle was automatically
cancelled.
Always load large
and
small items
together into the drum.(see also
imbalance compensation system).
Spin result unsatisfactory.
The
Rinse
O
or
Spin
Í
programme selected maximum spin
speed:see page 18.
Spin cycle actuated several times. Not a fault.
Unbalanced load detection system is attempting to compensate the
imbalance by spinning the washing several times.
Fault
Cause
Remedial action
