Bosch TES55236, Инструкция по эксплуатации

Страница: 31 / 52

27
TES552... | 05/2013
en
Display messages
The display (15) shows not only the current
operating status, but also various mes-
sages that give you status information or
let you know when you need to take action.
As soon as you have taken the necessary
action, the message disappears and the
menu for drink selection is displayed again.
Before using for the
fi rst time
General
Fill the water tank with fresh, cold, uncar-
bonated water only, and preferably use
only beans for fully automatic coffee and
espresso machines. Do not use coffee
beans that have been glazed, caramelised
or treated with other additives containing
sugar, since they will block the brewing unit.
The water hardness setting can be adjusted
on this appliance. The factory default setting
for the water hardness is 4. Check the
water hardness with the enclosed test strip.
If the check reveals a value other than 4,
change the setting on the appliance accord-
ingly after switching on (see “Menu settings”
Water hardness
on page 30).
Switching on the appliance
1. Remove the protective fi lm.
2. Place the fully automatic espresso
machine on a fl at, water-resistant
surface that can take its weight. Make
sure that the machine’s ventilation slots
remain unobstructured.
Important:
Only use the appliance in
frost-free rooms. If the appliance has been
transported or stored at temperatures below
0 °C, wait at least 3 hours before operation.
3. Pull the power cord out of the storage
compartment (20) and plug in. Adjust
the length of the cable by pushing it
back in or pulling it out. The easiest way
to do this is to place the appliance so
that its back is fl ush with the edge of the
counter and either pull the cable
down-
ward
or push it
upward
.
4. Install the milk frother. Operate the
machine only after the milk frother (6)
has been fully assembled and installed.
5. Lift the lid of the water tank (17).
6. Remove and rinse the water tank (16)
and fi ll it with fresh cold water.
Do not fi ll above the max mark.
7. Replace the water tank (16) and push it
fi rmly downward into place.
8. Close the lid of the water tank (17)
again.
9. Fill the bean container (1) with coffee
beans. (For preparation using ground
coffee, see “Preparation using
ground coffee” on page 31.)
10. Press the power switch O / I (9). The
display (15) shows the menu for setting
the display language.
11. Select the required display language
with the upper rotary knob (14). The
following languages are available:
русский
English
12. Press the
start
button (10). The
language you selected is saved. The
display shows
Pull milk frother
.
13. Place a receptacle under outlet.
14. Carefully pull out the milk frother (6) to
open it. The appliance rinses out the
milk frother (6) with water. The display
shows
Push milk frother
.
TES55236RU.indb 27 04.06.2013 14:35:44