14
Bosch Home Appliances
en
3..
Fill the water tank (5) up to the
descaling mark “0,5 l” (5b) and add the
descaling agent in accordance with the
manufacturer’s instructions�
i
i
Note:
If you have hard water, increase the
amount of descaling agent�
4..
Replace the water tank by tilting it
slightly and returning it to its original
position until it clicks into place�
5..
Place a container with a capacity of
at least 17 oz� / 500 ml under the drink
outlet (4d)�
6..
Open the brewing unit (4) by lifting
the handle (4a) and then pushing the
brewing unit up� Place the Service
T DISC (6a) on the T DISC holder (4b)
with the barcode facing down� Make
sure that the flap of the T DISC is
located in the slot in the front�
►
Close the brewing unit by first bringing
it down and then pushing the handle
firmly into the machine until you hear an
audible click�
7..
Press and
hold
the Start / Stop button
(2) for
at.least.5.seconds
to start the
descaling program�
►
Release the Start / Stop button after
5 seconds; the machine will run the
descaling cycle automatically� This is
indicated by the Status LED
F
(3a) and
“Descale required” LED
'
(3c) blinking�
i
i
Note:
The descaling solution is pumped through
the machine in intervals and then runs into
the container until the water tank is almost
empty� A small amount of liquid is always
left in the tank�
3.
4.
5.
6.
min�
17 oz� /
500 ml
7.
5 sec�
20.min.
.
!
. IMPORTANT
The descaling program runs for
approximately
20.minutes
�
