Troubleshooting
aus
49
Fault
Cause and troubleshooting
Appliance does not
start.
1.
Check whether the socket works.
2.
Check whether the mains cable is properly inserted
in the socket and on the rear of the appliance.
Appliance door is not closed properly.
▶
Close the appliance door.
Programme starts
automatically.
You did not wait until programme ended.
▶
"Terminate programme", Page 31
Appliance stops dur-
ing the programme or
cuts out.
Appliance door is not closed properly.
▶
Close the appliance door.
Power and/or water supply has been interrupted.
1.
Check the power supply.
2.
Check the water supply.
Top basket is pressing against inner door and pre-
venting appliance door from being closed securely.
▶
Check whether the rear panel of the appliance is
being pressed in by a socket or hose holder that
has not been removed.
▶
Arrange the tableware so that no parts project bey-
ond the basket and prevent the appliance door
from closing properly.
All LEDs lit up or
flashing.
Electronics have detected a fault.
1.
Press the main switch button for approx.
4 seconds.
→
The appliance is reset and restarted.
2.
If the problem occurs again:
‒
Switch off the appliance.
‒
Pull out the mains plug or switch off the fuse in
the fuse box.
‒
Wait at least 2 minutes.
‒
Switch on the fuse in the fuse box or insert the
mains plug.
‒
Switch the appliance on.
3.
If the problem occurs again:
‒
Contact customer service.
→
Fault
Cause and troubleshooting
Appliance door can-
not be closed.
Door lock has been activated.
▶
Close the appliance door with greater force.
Door cannot be closed due to installation method.