Bosch SMI50C02GB, Руководство по эксплуатации

Страница: 34 / 38

en Installation and connection
34
Fresh water connection
1. Connect the fresh-water connection
to the tap according
to the installation instructions with
the enclosed parts.
Ensure that the fresh-water
connection is not kinked,
crushed or twisted.
2. When replacing the appliance,
always use a new water supply hose.
Water pressure:
at least 0.05 MPa (0.5 bar), maximum
1 MPa (10 bar). At a higher water
pressure: connect pressure-reducing
valve ahead.
Inlet rate:
minimum 10 litres/minute
Water temperature:
Note printing on the water inlet hose!
If models are marked with 25°,
the water temperature may be max.
25 °C (cold water).
For all other models:
cold water preferred; hot water max.
temperature 60 °C.
Warm water connection
Warm water connection
* depending on model
The dishwasher can be connected
to cold or hot water up to max. 60 °C.
Connection to hot water
is recommended if the hot water can be
supplied by energetically favourable
means and from a suitable installation,
e. g. solar heating system with
circulation line.
This will save energy and time.
The hot water setting
‘
:
‹‚
allows you
to adjust your appliance optimally
to operation with hot water.
It is recommended to have a water
temperature (temperature of the
incoming water) of at least 40 °C
and no more than 60 °C.
It is not recommended to connect
the appliance to hot water if the water
is supplied from an electric boiler.
Setting hot water:
1.
Close the door.
2. Switch on ON/OFF switch
(
.
3. Press and hold down the START
button
@
.
4. Rotate programme selector
8
until
‘
:
‹‚
is indicated on the digital
display
H
.
5. Release button.
The factory-set value
‘
:
‹‹
is lit on
the digital display
H
.
To change the setting:
1.
By rotating the programme
selector
8
, you can switch the hot
water setting off
‘
:
‹‹
or on
‘
:
‹‚
.
2. Press START button
@
.
The set value is saved.